![]() ![]() Input over current protection of power supply primary side The power supply needs 220~230 volts of stable voltage for optimum performance. Over-temperature Protection for Power Input The power supply protection turned it off due to low voltage.Ģ) The voltage regulator (if there is one) is failingģ) There is a relay voltage regulator, because of its design the voltage drops for a short period of time, but this time is enough for the power supply to trigger the protection The power supply protection turned it off due to high voltage. Turn off the ASIC for 10 minutes, then try again. Turn off the ASIC for about 10 minutes, then try again.Ĭheck the tightness of the screws on the voltage distribution bus. The ASIC needs 230 volts to operate in high mode, the mains is less than 230 volts. Power input voltage is lower than 230V for high power mode Power input voltage and current do not match the power This error indicates undervoltage in the mains, check the incoming voltage.Ĭheck the mains input voltage, the power supply needs 220~240 volts to operate stably.Ĭheck the error status of the power supply. Power supply and configuration file mismatchĬheck the temperature of the incoming flow.Ĭlean the hash boards, control board and the boards' adapter from dirt and put everything back together. Test the network connection cable of the ASIC.įlash the ASIC with the SD card and then with WhatsMinerTool. Pay attention to the temperatures of the incoming airflow. ![]() Inspect the fan connector and ensure it is connected correctly.ĭue to the high temperature, the ASIC is trying to cool itself by increasing the fan speed.Ĭlean the ASIC from various types of dirt. It is recommended to replace them with original ones to eliminate possible problems. ![]() Non-original or refurbished fans may not produce the correct speed or may be faulty initially. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |